Park/Turn Signal Lamp - Installation

LAMP





1. Position the front park/turn signal lamp to the outer surface of the front fascia by inserting the studs on the back of the lamp housing into the mounting holes of the fascia.
2. Install and tighten the two nuts (3) that secure the studs of the lamp housing to the inside surface of the front fascia (1). Tighten the nuts securely.
3. Reconnect the wire harness connector (2) to the connector receptacle integral to the bulb socket.
4. Reinstall the liner to the front of the front fender wheel house. Splash Shield - Installation.
5. Reconnect the battery negative cable.