Electronic Stability Program (ESP) Switch - Installation

INSTALLATION






NOTE: There are different accessory switch banks available based on the option content of the vehicle. Ensure the switch pod being installed matches the vehicle options.

1. Position the accessory switch bank (3) onto the back of the instrument panel center bezel (1).
2. Install the four screws (2) that secure the accessory switch bank to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel, Instrument Panel Bezel - Installation.
4. Connect the battery negative cable.
5. Verify esp system operation.