Half Shaft - Removal

REMOVAL





1. With vehicle in neutral, position vehicle on hoist.
2. Remove brake caliper and rotor.
3. Remove nut (1) from half shaft (2).





4. Remove sensor (1) from hub bearing (2).





5. Remove stabilizer link from stabilizer bar.
6. Remover tie rod end (1) nut and remove tie rod from steering knuckle (2).





7. Remove clevis bracket (1) lower nut (2) and bolt.





8. Remove upper ball joint nut and separate upper control arm from steering knuckle.
9. Pull out on the steering knuckle and push half shaft (1) out of the hub bearing and knuckle (2).
10. With a pry bar remove the half shaft from the axle.