Rear Door Glass - Installation

INSTALLATION


NOTE: The following two graphics are shown with the carrier removed for clarity.






1. Install the door glass to the window opening in the door.

2. Verify the the glass is seated into both glass run channels.






3. Push the glass (1) down and seat the clips (2) fully.

4. Pull up on the glass and make sure that it is secure.






5. Position the quarter glass (2) back into the window opening.


6. Twist the top of the fixed glass (2) back into place and seat the glass into the door frame fully.

7. Seat the glass run seal (1) around the door frame fully.






8. Install the devision bar bolt (1).






9. Press the belt molding onto the trim panel flange starting at the rear and working forward.

10. Install the trim panel. Rear Door Trim Panel - Installation






11. Cycle the window several times to make sure the window doesn't bind on the outer weatherstrip or run channel.