Instrument Panel Demister Duct - Installation

INSTALLATION

NOTE: LHD model shown in illustrations. RHD model similar.

DRIVER SIDE

NOTE: The inner driver side demister duct is serviced only as an assembly with the driver side instrument panel duct.





1. If removed, connect the outer demister duct (1) to the driver side demister duct (3).
2. Position the driver side instrument panel duct (6) and demister duct to the instrument panel support and connect the driver side instrument panel duct to the passenger side instrument panel duct (5). Make sure the ducts are fully engaged to each other.
3. Connect the demister hose (4) to the driver side demister duct. Make sure the hose is fully engaged to the duct.
4. Install the four screws (2 and 7) that secure driver side instrument panel duct and demister duct to the instrument panel support. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Install the lower and upper instrument panel covers Instrument Panel Cover - Installation.

PASSENGER SIDE





1. Position the passenger side demister duct (4) behind the instrument panel support. Rotate and tilt the duct as required.
2. Engage the demister duct retaining tab (2) to the instrument panel support.
3. Engage the push-pin type fastener (3) to the instrument panel support.
4. Connect the demister hose (1) to the demister duct. Make sure the hose is fully engaged to the duct.
5. Install the lower and upper instrument panel covers Instrument Panel Cover - Installation.