B1935

B1935-PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

Theory of Operation

This trouble code is for the Right Door Lock Switch for all vehicles including right hand drive.

- When Monitored:
Continuously

- Set Condition:
When the Right Door Lock Switch Mux circuit is between 0.8 and 3.5 volts for over 10 seconds.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs.
2. Operate the Right Door Lock Switch in all positions several times.
3. Cycle the ignition from on to off.
4. Turn the ignition on.
5. With the scan tool, read DTCs.

Does the scan tool display B1935-PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. DOOR LOCK SWITCH SHORTED




1. With the scan tool, erase DTCs.
2. Disconnect the Right Door Lock Switch connector.
3. With the scan tool, read DTCs.

Does the scan tool display B1935-PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK?

No

- Replace the Right Door Lock Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Go To 3

3. (G160) RIGHT DOOR LOCK SWITCH MUX CIRCUIT PARTIAL SHORTED TO GROUND




1. Turn the ignition off.
2. Disconnect the TIPM C7 connector.
3. Measure the resistance between ground and the (G160) Right Door Lock Switch Mux circuit.

Is the resistance below 10,000 Ohms?

Yes

- Repair the (G160) Right Door Lock Switch Mux circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (G160) RIGHT DOOR LOCK SWITCH MUX CIRCUIT SHORTED TO THE (P37) DOOR LOCK SWITCH RETURN




1. Measure the resistance between the (G160) Right Door Lock Switch Mux circuit and the (P37) Door Lock Switch Return circuit.

Is the resistance below 10,000 Ohms?

Yes

- Repair the (G160) Right Door Lock Switch Mux circuit for a short to the (P37) Door Lock Switch Return circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.