Valve Body - Assembly

ASSEMBLY

NOTE: If the valve body assembly is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure using a Scan Tool. Quick Learn Procedure










1. Install all valves and springs as shown.










2. Install regulator valve spring retainer (2).










3. Install dual retainer plate (2) using Tool 6301 (1).










4. Verify that all retainers (1, 2) are installed as shown. Retainers should be flush or below valve body surface.










5. Install 2/4 Accumulator components (1-5) as shown. Torque 2/4 Accumulator retainer plate to 5 Nm (45 in. lbs.).










6. Install check balls into position as shown. If necessary, secure them with petrolatum or transmission assembly gel for assembly ease.










7. Install thermal valve (1) to the transfer plate.










8. Install the oil screen (1) to the transfer plate.










9. Install separator plate (1) to transfer plate (2).










10. Install the two separator plate-to-transfer plate screws (2).










11. Install the transfer plate (1) to the valve body (2).










12. Install the transfer plate-to-valve body screws (1) and torque to 5 Nm (45 in. lbs.).










13. Install the stiffener plate (1).










14. Install the solenoid/pressure switch assembly (1) and screws to the transfer plate and torque to 5.5 Nm (50 in. lbs.).










15. Install the manual shaft/rooster comb (3) and transmission range sensor (1) to the valve body.










16. Install the TRS/manual shaft retaining screw (1) and torque to 5 Nm (45 in. lbs.).
17. Install manual shaft seal.