Defroster Duct - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.






NOTE: LHD model shown. RHD model similar.

1. Remove the instrument panel and place it on a workbench Instrument Panel - Removal.
2. Remove the instrument panel cover Instrument Panel Cover - Removal.
3. Remove the right and left demister ducts (1 and 3) Instrument Panel Demister Duct - Removal.

NOTE: If the foam seal on the top of the HVAC housing is deformed or damaged, the seal must be replaced.

4. Remove the four screws (2) that secure the defroster duct (6) to the instrument support (4) and the HVAC housing assembly (5) and remove the duct.