Tail Stop Turn Lamp - Installation
LAMP
1. Check to be certain that the two spring nuts (2) are in good condition and properly installed in the rear body sheet metal.
2. Position the rear lamp unit (4) to the lamp opening of the rear body sheet metal.
3. Reconnect the body wire harness connector (1) to the bulb socket pigtail wire connector on the back of the lamp housing.
4. Engage the two tabs on the back of the lamp housing with the outboard edge of the lamp opening in the rear body sheet metal.
5. Align the mounting holes on the inboard side of the lamp to the two spring nuts.
6. Install and tighten the two screws (3) that secure the inboard side of the rear lamp unit to the body sheet metal. Tighten the screws to 1.5 Nm (15 in. lbs.).
7. Reconnect the battery negative cable.