Front

LAMP





1. Position the front fog lamp housing (1) to the back of the front bumper cover (2). Be certain that the two alignment pins on the back of the front bumper cover are engaged in the alignment holes in the lamp housing.
2. Install and tighten the four screws (3) that secure the lamp to the back of the front bumper cover. Tighten the screws to 2 Nm (18 in. lbs.).
3. Reconnect the engine compartment wire harness connector (4) to the fog lamp bulb connector receptacle.
4. If it was removed during bulb removal, reinstall the front bumper lower air dam onto the vehicle.
5. Lower the vehicle.
6. Reconnect the battery negative cable.
7. Confirm proper front fog lamp alignment. Adjustments.