Passenger Door Module (PDM)

U1000-CAN B BUS (+) CIRCUIT





For a complete wiring diagram Refer to the Wiring Information.

- When Monitored:
Continuously

- Set Condition:
Whenever the CAN B Bus (+) or CAN B Bus (-) circuit is open.





1. CHECK FOR ACTIVE DTCS
1. With the scan tool, read the active DTCs.
2. Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
3. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. CHECK FRONT CONTROL MODULE DTCs
1. With the scan tool, read Front Control Module active DTCs

Does the scan tool display any CAN B BUS DTCs - ACTIVE?

Yes

- Perform the appropriate test.
- Testing and Inspection

No

- Go To 3

3. (D55) CAN B BUS (+) CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the negative battery cable.
3. Disconnect the Passenger Door Module C2 connector.
4. Disconnect the Front Control Module C1 connector.
5. Measure the resistance of the (D55) CAN B Bus (+) circuit between the Front Control Module C1 connector and the Door Module C2 connector.

Is the resistance below 2.0 ohms?

Yes

- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (D55) CAN B Bus (+) circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.