D. (WK/XK) Jeep Grand Cherokee & Commander WIN Replacement

1. Disconnect and isolate the battery negative cable.





2. Unsnap the cluster bezel from the instrument panel (Figure 6).





3. Remove the knee bolster from the instrument panel (Figure 7).

4. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the bezel around the ignition switch until it unsnaps from the instrument panel (Figure 7).





5. Remove the four WIN mounting screws that secure the WIN to the instrument panel support structure, (Figure 8).

6. If equipped, disconnect the remote start system antenna module coaxial cable connector from the WIN connector receptacle.

7. Disconnect the instrument panel wire harness connector from the WIN connector receptacle.

8. Remove the WIN from the instrument panel.

9. Position the new WIN to the instrument panel.

10. Connect the instrument panel wire harness connector to the WIN connector receptacle.

11. If equipped, connect the remote start system antenna module coaxial cable connector to the WIN connector receptacle.

12. Install and tighten the four screws that secure the WIN to the instrument panel support structure. Tighten the screws securely.

13. Position the bezel around the ignition switch on the instrument panel, then press firmly and evenly on the bezel until it snaps into place.

14. Install the knee bolster onto the instrument panel.

15. Install the cluster bezel onto the instrument panel.

16. Connect the battery negative cable.

17. Continue with Section E. Obtaining Vehicle Personal Identification Number (PIN).