B10AD

B10AD-RIGHT BLEND DOOR TRAVEL RANGE TOO SMALL

For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation

The A/C Heater Control calibrates each actuator individually. Automatic calibration occurs upon power up after installing a new A/C Heater Control. Manual calibration occurs by sending a command with the scan tool. The purpose of actuator calibration is to determine the total span of door travel between physical stops. To calibrate the actuator, the A/C Heater Control first moves the door to its soft stop, and then counts the number of pulses it takes to move the door to its other stop. An expected range of span is stored in the control's memory. If the measured calibration value is less than the expected range for this actuator, this DTC will set. Note that the control clears all stored calibration faults at the beginning of the calibration procedure.

- When Monitored:
During actuator calibration.

- Set Condition:
If the total span of the Right Blend Door is less than the low range limit.





1. CHECK FOR ACTIVE CONTROL CIRCUIT/PERFORMANCE AND CONTROL CIRCUIT OPEN DTCs
1. Turn the ignition on.
2. With the scan tool, read active HVAC DTCs.

Does the scan tool display any active: XXXX CONTROL CIRCUIT/PERFORMANCE or XXXX CONTROL CIRCUIT OPEN DTCs?

Yes

- Diagnose and repair the DTC(s). If present, diagnose and repair all Control Circuit/Performance DTCs before diagnosing Control Circuit Open DTCs. Testing and Inspection.

No

- Go To 2

2. INSPECT ACTUATOR AND HOUSING ASSEMBLY FOR A CONDITION CAUSING THE RIGHT BLEND DOOR TO SEIZE OR BIND
1. Turn the ignition off.
2. Inspect the actuator, linkage, and housing assembly for a condition causing the right blend door to seize or bind.

Are there any physical or mechanical problems with the door, housing, linkage, or actuator?

Yes

- Repair as necessary.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. CHECK RIGHT BLEND DOOR TRAVEL
1. Remove the Right Blend Door Actuator from the A/C Heater Housing Assembly.
2. By hand, attempt to rotate the door in both directions. The door should operate smoothly in both directions over the entire span of travel (approximately 90 degrees).

Does the door operate smoothly in both directions over the entire span of travel?

Yes

- Replace the Right Blend Door Actuator. Then, Go To 4.

No

- Repair as necessary.
- Perform BODY VERIFICATION TEST. Body Verification Test.

4. RUN THE ACTUATOR CALIBRATION TEST
1. Turn the ignition on.
2. With the scan tool, select System Tests and then select Actuator Calibration Test. When the test is complete, select View DTCs.

Does the scan tool display: B10AD-RIGHT BLEND DOOR TRAVEL RANGE TOO SMALL?

Yes

- Replace the A/C Heater Control.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Perform BODY VERIFICATION TEST. Body Verification Test.