Operation CHARM: Car repair manuals for everyone.

B1809






B1809-PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK UNLOCK





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously

- Set Condition:
When the Passenger Door Lock Switch Mux circuit is between 0.5 volts and 1.5 volts for over 30 seconds,.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Operate the Passenger Door Lock Switch in both positions several times.
3. Cycle the ignition from on to off 3 times.
4. Turn the ignition on.
5. With the scan tool, read DTCs.

Does the scan tool display B1809-PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK UNLOCK?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST Body Verification Test.

2. PASSENGER DOOR LOCK SWITCH SHORTED TO GROUND




1. With the scan tool, erase DTCs.
2. Disconnect the Passenger Window/Door Lock Switch connector.
3. Turn the ignition on.
4. With the scan tool, read DTCs.

Does the scan tool display DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK UNLOCK?

No

- Replace the Passenger Window/Door Lock Switch.
- Perform the BODY VERIFICATION TEST Body Verification Test.

Yes

- Go to 3

3. (G160) (LHD) OR (G161) (RHD) DOOR LOCK SWITCH MUX CIRCUIT SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the Passenger Door Module C2 connector.
3. Measure the resistance between ground and the (G160/LHD) or (G161/RHD) Door Lock Switch Mux circuit in the Passenger Door Module C2 connector.

Is the resistance below 10000.0 ohms?

Yes

- Repair the (G160) or (G161) Door Lock Switch Mux circuit for a short to ground.
- Perform the BODY VERIFICATION TEST Body Verification Test.

No

- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST Body Verification Test.