B1982

B1982-POWER LIFTGATE LATCH CONTROL 1 CIRCUIT OPEN





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Anytime the Power Liftgate is performing a power cinching or releasing operation.

- Set Condition:
When the power liftgate latch module detects an open circuit between the latch motor outputs.





1. DIAGNOSTIC TROUBLE CODE (DTC) PRESENT
1. Using the scan tool, record and erase DTCs.
2. Turn the ignition off, wait 10 seconds, then turn the ignition on.
3. Operate the power liftgate several times if possible.
4. Using the scan tool, read DTCs.

Does the scan tool display B1982-POWER LIFTGATE LATCH CONTROL 1 CIRCUIT OPEN?

Yes

- Go To 2

No

- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. Operate the liftgate several times and check for any binding conditions in the latch assembly.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. LIFTGATE LATCH CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the Power Liftgate Module C2 harness connector.
3. Measure the resistance between the (Q84) Liftgate Latch Cinch Driver circuit and the (Q85) Liftgate Latch Release Driver Circuit.

Is the resistance approximately 4.0 Ohms?

Yes

- Replace the Power Liftgate Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. (Q84) LIFTGATE LATCH CINCH DRIVER CIRCUIT OPEN




1. Disconnect the Power Liftgate Latch harness connector.
2. Measure the resistance of the (Q84) Liftgate Latch Cinch Driver circuit between the Power Liftgate Module C2 harness connector and the Power Liftgate Latch harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Go To 4

No

- Repair the (Q84) Liftgate Latch Cinch Driver circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. (Q85) LIFTGATE LATCH RELEASE DRIVER CIRCUIT OPEN




1. Measure the resistance of the (Q85) Liftgate Latch Release Driver circuit between the Power Liftgate Module C2 harness connector and the Power Liftgate Latch harness connector.

Is the resistance below 5.0 Ohms?

Yes

- Replace the Liftgate Latch assembly.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (Q85) Liftgate Latch Release Driver circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.