B1A6B

B1A6B STEERING COLUMN LOCK MODULE NOT INITIALIZED

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
The Wireless Ignition Node detects that the Steering Column Lock Module has not initialized. The WIN has been enabled with the Steering Wheel Lock Module but did not personalized





1. STEERING COLUMN LOCK MODULE
1. With the scan tool, record and erase WIN DTCs.
2. Remove and insert the key from the ignition switch several times then leave the key in the run position.
3. With the scan tool, read the active DTCs.

Does the scan tool display: B1A6B STEERING COLUMN LOCK MODULE NOT INITIALIZED?

Yes

- Go To 2

No

- Perform the WIRELESS IGNITION NODE (WIN) INTERMITTENT TEST.Wireless Ignition Node (WIN) Verification Test).

2. INITIALIZE STEERING COLUMN LOCK MODULE
1. With the scan tool, erase the DTCs in the WIN.
2. With the scan tool, perform the Steering Wheel Lock Module (ELV) Replaced routine.
3. Turn the Ignition off, wait 15 seconds then turn the ignition back on.
4. Remove and insert the key from the ignition switch several times then leave the key in the run position.
5. With the scan tool, read the DTCs.

Does the scan tool display: B1A6B STEERING COLUMN LOCK MODULE NOT INITIALIZED?

Yes

- Replace the Steering Column Lock Module. The Wireless Ignition Node (WIN) must also be replaced along with the Steering Column Lock Module (ELV). When replacing the WIN and the Steering Column Lock Module (ELV), the WIN MUST be programmed BEFORE the Steering Column Lock Module (ELV) is programmed..
- Replace and program the Wireless Ignition Node (WIN). Wireless Ignition Node Receiver - Removal.
- Replace and program the Steering Column Lock Module (ELV). Shaft Lock Module - Removal.
- Perform the WIN VERIFICATION TEST. Wireless Ignition Node (WIN) Verification Test.

No

- Test complete
- Perform the BODY VERIFICATION TEST. Body Verification Test.