B1BA5

B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH





For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation
When powered, the Occupant Restraint Controller (ORC) sends a test current to the squibs. During this test, the squibs discovered are checked for agreement with the pre-programmed vehicle configuration of components assigned to the module.
- When Monitored:
With the ignition on.

- Set Condition:
If an Occupant Restraint Controller (ORC) configured for vehicles without side airbags is installed in a vehicle with side airbags.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.

1. VERIFY THAT DTC B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH IS ACTIVE

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.

Does the scan tool display active: B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH?

Yes

- Go To 2

No

- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. . Restraints System Intermittent Condition Test

2. CHECK ORC PART NUMBER WITH SCAN TOOL
1. With the scan tool, select ECU View, select ORC, select ECU Details, and read the ORC part number.

Is the part number correct for the vehicle?

Yes

- Go To 3

No

- Replace the ORC.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

3. CHECK VIN WITH SCAN TOOL
1. With the scan tool, read the VIN.

Is the correct VIN displayed?

Yes

- Replace the ORC.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.

No

- Replace the Engine Control Module (ECM) or Powertrain Control Module (PCM).
- Perform ECM/PCM VERIFICATION TEST. Powertrain Verification Test or . Powertrain Verification Test