B1D07

B1D07-MIRROR ADJUST SWITCH INPUT CIRCUIT STUCK





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
When mirror operation is requested.

- Set Condition:
If the Driver Door Module detects that the Mirror Switch is stuck in the same position for more than 30 seconds.





1. VERIFY IF DTC B1D04-MIRROR ADJUST SWITCH INPUT CIRCUIT/PERFORMANCE IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Press the Mirror Switch in all directions several times.
4. Cycle the ignition from on to off three times.
5. Turn the ignition on.
6. With the scan tool, read the active DTCs.

Does the scan tool display: B1D04-MIRROR ADJUST SWITCH INPUT CIRCUIT/PERFORMANCE?

Yes

- Diagnose and repair the B1D04 DTC. Testing and Inspection.

No

- Go To 2

2. TEST THE MIRROR SWITCH
1. Turn the ignition off.
2. Remove the Mirror Switch.
3. Disconnect the Mirror Switch connector.
4. Test the Mirror Switch in all positions. Testing and Inspection.

Does the switch pass the test in all positions?

Yes

- Go To 3

No

- Replace the Mirror Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. VERIFY THAT DTC B1D07-MIRROR ADJUST SWITCH INPUT CIRCUIT STUCK IS STILL ACTIVE
1. Turn the ignition off.
2. Reconnect the Mirror Switch connector.
3. Reinstall the Mirror Switch.
4. Turn the ignition on.
5. With the scan tool, erase the DTCs.
6. Press the Mirror Switch in all directions several times.
7. Cycle the ignition from on to off three times.
8. Turn the ignition on.
9. With the scan tool, read the active DTCs.

Does the scan tool display: B1D07-MIRROR ADJUST SWITCH INPUT CIRCUIT STUCK?

Yes

- Replace the Driver Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. If the conditions returns, replace the switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.