B2208

B2208-OCCUPANT RESTRAINT CONTROLLER INTERNAL 2

- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure .
REPLACE OCCUPANT RESTRAINT CONTROLLER
1. Turn the ignition on.

WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.

When this code is set, view repair.

Repair

- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.