C1210

C1210-G SENSOR INPUT CIRCUIT PERFORMANCE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously, with ignition on, until vehicle speed exceeds 20 km/h (12.4 mph) for the first time, but not if the sensor voltage is out of range.

Or, during diagnostic mode.

Or, if the monitoring was inhibited by a corresponding diagnostics command.

- Set Condition:
If the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.





CHECK FOR A DTC C1210-G SENSOR INPUT CIRCUIT PERFORMANCE

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record information.
4. With the scan tool, erase DTCs.
5. Cycle the ignition switch from off to on.
6. With the scan tool, read and record DTCs.

Does the scan tool display: C1210-G SENSOR INPUT CIRCUIT PERFORMANCE?

Yes

- Replace the Dynamics Sensor.
- Perform ABS VERIFICATION TEST ABS Verification Test.

No

- Perform the INTERMITTENT CONDITION diagnostic procedure ABS Intermittent Condition Test.