C1232

C1232-DRIVE TEST: PRESSURE SENSOR

For a complete wiring diagram,refer to the Wiring Information.

- When Monitored:
During the Drive Test.

- Set Condition:
If the Pressure Sensor fails to activate.





1. CHECK FOR A DTC C1232-DRIVE TEST: PRESSURE SENSOR

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.
4. Perform ECU initialization with drive test. Refer to ABS VERIFICATION TEST ABS Verification Test.
5. Start the engine.and apply the brake firmly.
6. With the scan tool, read and record DTCs.

Does the scan tool display: C1232-DRIVE TEST: PRESSURE SENSOR?

Yes

- Go To 2

No

- Perform the ABS INTERMITTENT CONDITION TEST ABS Intermittent Condition Test.

2. CHECK HYDRAULIC SYSTEM AND BRAKE SYSTEM COMPONENT INSTALLATION AND FUNCTION
1. Verify that the Anti-Lock Brake Module and Hydraulic Control Unit are properly installed.
2. Verify that the hydraulic system is properly filled and bled.
3. Verify that the brake system components are installed and functioning properly.

Were any problems found?

Yes

- Repair as necessary.
- Perform ABS VERIFICATION TEST ABS Verification Test.

No

- Clean contacts in HCU first if problem reoccurs replace the Integrated Control Unit.
- Perform ABS VERIFICATION TEST ABS Verification Test.