C2206

C2206-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
When the Anti-Lock Brake Module detects the signal from the gateway module relevant for vehicle characteristic is missing for a period greater than the specified fault duration.





CHECK FOR A DTC C2206-VEHICLE CONFIGURATION MISMATCH

NOTE: This DTC must be active for the results of this test to be valid. Diagnose and repair any communication DTCs in the Front Control Module (FCM) before continuing with this test.

NOTE: Diagnose and repair any system under voltage or over voltage DTCs before continuing with this test.

1. Turn the ignition on.
2. With the scan tool, read the DTCs.
3. With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.
4. With the scan tool, erase the DTCs.
5. Cycle the ignition switch off then on.
6. With the scan tool, read the DTCs.

Does the scan tool display: C2206-VEHICLE CONFIGURATION MISMATCH?

Yes

- With the scan tool select FCM under ECU selection then Misc Functions and Restore Vehicle Configuration.

No

- Perform the ABS INTERMITTENT CONDITION TEST ABS Intermittent Condition Test.