U0195

U0195-LOST COMMUNICATION WITH SDAR

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Front Control Module (FCM) is configured correctly.

- Set Condition:
Bus messages not received from the Satellite Receiver (SDAR) for approximately two to five seconds.





VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Perform the U0195-Lost Communication with SDAR diagnostic procedure. U0195

No

- Perform the Stored Lost Communication DTCs diagnostic procedure. Stored Lost Communication DTCs