U1413

U1413-IMPLAUSIBLE ODOMETER SIGNAL RECEIVED





For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation

The Front Control Module isn't receiving an odometer signal over CAN B from the Cluster Module. The FCM has to send the PCM an odometer signal over CAN C. The signal the FCM is sending over CAN C is implausible.

- When Monitored:
Ignition on.

- Set Condition:
The odometer message the PCM is receiving is implausible. The circuit is continuously monitored. One Trip fault.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. ACTIVE DTC
1. Ignition on, engine not running.
2. With a scan tool, View DTCs.

Is the DTC Active at this time?

Yes

- Go To 2

No

- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Intermittent Condition Test.

2. CAN B BUS HARDWARE DTCS ALSO ACTIVE
1. With a scan tool check for DTCs in the FCM.

Are any CAN B Hardware related DTCs Active at this time?

Yes

- Testing and InspectionPerform the appropriate diagnostic procedure.

No

- Replace and program the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.