Front

LAMP - FRONT





1. Insert the fixed retainer on the switch end of the reading lamp housing (2) into the mounting hole in the headliner.
2. Reconnect the wire harness connector (4) to the connector receptacle on the back of the lamp.
3. With the lens (1) positioned perpendicular to the housing, slide the switch end of the housing into the mounting hole far enough to engage the lens hinge/retainer (3) into the opposite side of the hole in the headliner.
4. Gently and evenly press the lens hinge/retainer end of the lamp into the mounting hole until the bezel of the lamp housing is flush with the headliner.





5. Swing the switch end of the lens (2) back into position against the lamp housing (1), then using hand pressure press on the switch end of the lens firmly and evenly until it snaps into the housing.
6. Reconnect the battery negative cable.