Cylinder Head Assembly: Specifications

CYLINDER HEAD









Tighten the bolts in sequence using the following steps and torque values:
Step 1: Tighten bolts 1-8 27 Nm (20 ft. lbs.).
Step 2: Verify that bolts 1-8, all reached 27 Nm (20 ft. lbs.), by repeating step 1 without loosening the bolts.
Tighten bolts 9 thru 12 14 Nm (10 ft. lbs.).
Step 3: Tighten bolts 1-8, 90°.
Step 4: Tighten bolts 1-8, 90°, again.
Tighten bolts 9-12 26 Nm (19 ft. lbs.)


HEAD BOLTS REUSE/REPLACE

The bolts must be examined BEFORE reuse. If the threads are necked down the bolts should be replaced.

SURFACE VARIATION - HEAD-TO-BLOCK

Inspect the cylinder head for out-of-flatness, using a straightedge and a feeler gauge. If tolerances exceed 0.0508 mm (0.002 in.) replace the cylinder head.

SURFACE VARIATION - WARPAGE

Cylinder Head Warpage (Flatness) 0.0508 mm (0.002 in.).

CAMSHAFT BEARING CAP





Camshaft Bearing Cap Bolts 11 Nm (100 in. lbs.)

INTAKE MANIFOLD

Intake Manifold Bolts Specifications

EXHAUST MANIFOLD

Exhaust Manifold Bolts Specifications

CAMSHAFT GEAR/SPROCKET

Camshaft Gear/Sprocket Specifications