Operation CHARM: Car repair manuals for everyone.

Transfer Case - Installation






INSTALLATION





1. Mount transfer case on a transmission jack.
2. Secure transfer case to jack with chains.
3. Position transfer case under vehicle.
4. Align transfer case (1) and transmission (3) shafts and install transfer case onto the transmission.
5. Install and tighten transfer case attaching nuts (2) to 35 Nm (26 ft. lbs.) torque.
6. Connect the transfer case vent hose (4).
7. Connect front propeller shaft and install rear propeller shaft. Drive Shaft - Installation










8. For NV140, fill transfer case with correct fluid. Description - Engine Coolant Correct as necessary.
9. Install the transfer case fill plug (1). Tighten the plug to 20-34 Nm (15-25 ft.lbs.).
10. Install rear crossmember and skid plate, if equipped. Tighten crossmember bolts to 41 Nm (30 ft. lbs.) torque.
11. Remove transmission jack and support stand.
12. Lower vehicle and verify transfer case shift operation.










13. For NV146, fill transfer case with correct fluid. Description - Engine Coolant Correct as necessary.
14. Install the transfer case fill plug (1). Tighten the plug to 20-34 Nm (15-25 ft.lbs.).
15. Install rear crossmember and skid plate, if equipped. Tighten crossmember bolts to 41 Nm (30 ft. lbs.) torque.
16. Connect the wiring connector to the shift motor.
17. Remove transmission jack and support stand.
18. Lower vehicle and verify transfer case shift operation.