B184E

B184E-FLIPPER GLASS CONTROL CIRCUIT LOW







- When Monitored:
Whenever the TIPM receives an unlatch command for the flip-up glass.

- Set Condition:
When the TIPM senses a low condition on the Flip-UP (Flipper) Glass Relay Output circuit for over 5 seconds, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Operate the Flip-Up Glass Switch several times.
3. Cycle the ignition from on to off 3 times.
4. Turn the ignition on.
5. With the scan tool, read DTCs.

Does the scan tool display B184E-FLIPPER GLASS CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. FLIP-UP GLASS LATCH




1. With the scan tool, erase the DTCs.
2. Disconnect the Flip-Up Glass Latch C1 connector.
3. Connect a 12-volt test light between the (Q81) Flip-Up Glass Relay output and the (Z920) Ground in Flip-Up Glass Latch connector.
4. With the scan tool actuate the Flip-Up Glass.
5. With the scan tool, read the DTCs.

Does the test light illuminate brightly when the Latch is actuated?

Yes

- Replace the Flip-Up Glass Latch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. (Q81) FLIP-UP GLASS RELAY OUTPUT CIRCUIT SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the TIPM C7 connector.
3. Measure the resistance between ground and the (Q81) Flip-Up Glass Relay Output circuit.

Is the resistance below 10,000 ohms?

Yes

- Repair the (Q81) Flip-Up Glass Relay Output circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.