Totally Integrated Power Module (TIPM)

B210D-BATTERY VOLTAGE LOW



- When Monitored:
With the ignition on.

- Set Condition:
Battery voltage less than 9 volts for approximately five to six seconds.





CHECK FOR ANY POWERTRAIN CONTROL MODULE (PCM) or ENGINE CONTROL MODULE (ECM) DIAGNOSTIC TROUBLE CODES (DTCS)

NOTE: Make sure the Battery is in good condition. Using the Midtronics Battery Tester, test the Battery before continuing.

NOTE: Inspect the vehicle for after market accessories that may exceed the Generator System output.

NOTE: Make sure the generator drive belt is in good operating condition.

NOTE: Inspect the fuses in the TIPM. If an open fuse is found, use the wire diagram/schematic as a guide, inspect the wiring and connectors for damage.

1. Turn the ignition on.
2. With the scan tool, read active PCM or ECM DTCs.

Does the scan tool display any active charging system or battery PCM or ECM DTCs?

Yes

- Testing and Inspection for gas applications or Testing and Inspection

No

- Check the above conditions that can cause a low voltage condition. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.