Battery Tray - Removal

REMOVAL






NOTE: Left hand drive gasoline engine shown, right hand drive and diesel similar.

1. Disconnect and isolate the battery negative cable.
2. Remove the battery, Battery - Removal.
3. On gasoline engine equipped vehicles, disconnect the purge solenoid vacuum hose and electrical connector (1). Using an appropriate flat bladed tool, remove the solenoid (4) from the battery tray (3) by disengaging the solenoid mounting clip and lifting it up off the battery tray mounting tab.





4. Open the Totally Integrated Power Module (TIPM) cover (4).
5. Remove the TIPM positive cable retaining nut (1) and remove the cable (2) from the mounting stud (3).





6. Using an appropriate flat bladed tool, depress the four mounting clips to disengage and remove the TIPM housing (1) from the TIPM bracket mounting tabs (3).





7. Disconnect each of the seven TIPM wire harness connectors from the TIPM housing (2).
8. Remove the TIPM from the vehicle.





9. Remove the TIPM bracket retaining screws (1) and slide the bracket (2) rearward to disengage the mounting tabs (3). Remove the TIPM bracket from the battery tray (4).





10. Remove the three nuts (1) securing the battery tray (2) to the left inner fender (3).
11. Lift the battery tray out of the engine compartment and remove from the vehicle.