A. Replace Right Front Door Latch (KA/KK Models)

1. Remove and save window switch (Figure 1).

2. Remove the inside door release handle lever bezel (Figure 1).

3. Remove the door panel retaining screw located behind the door release handle lever bezel (Figure 1).

4. Open the door panel lower access cover and remove the retaining screw (Figure 1 Insert).

5. Remove and save the door panel (Figure 1).





6. Remove and save the door speaker (Figure 2).

7. Disconnect the body-to-door wiring harness (Figure 2).

8. Disconnect side view mirror wiring harness (Figure 2).

9. Remove and save the inner door glass seal at the top of the door frame.

10. Disconnect the door glass from the window regulator lift channel and remove the door glass from the door.

11. Remove and save the door access plug to gain access to the outside door handle retaining nut (Figure 2).

12. Using a 10mm socket, remove and save the outside door handle nut.

13. Remove and save the black retaining screw located next to the weather strip

14. Remove and save the three door latch retaining screws (Figure 2).
15. Remove and save the carrier mounting bolts.

16. Remove the door carrier from the door.

17. Remove and discard the original door latch.

18. Install the new door latch.

19. Install the door carrier into the door.

20. Install the carrier mounting bolts (Figure 2).

21. Install the three door latch retaining screws (Figure 2).

22. Install the black retaining screw located next the door latch (Figure 2).

23. Using a 10mm socket, install the outside door handle nut and install then install the door access plug.

24. Install the door glass into the door and snap the door glass into the window regulator lift channel.

25. Install the inner door glass seal at the top of the door frame.

26. Connect the side view mirror wiring harness (Figure 2).

27. Connect the body-to-door wiring harness (Figure 2).

28. Install the door speaker (Figure 2).

29. Install the door panel.

30. Install the door panel lower retaining screw and access cover (Figure 1).

31. Install the door panel retaining screw located behind the door release handle lever bezel (Figure 1).

32. Install the inside door release handle lever bezel (Figure 1).

33. Install the window switch (Figure 1).

34. Check window glass and door latch operation.

35. Clean door glass as required.