Rear Door Carrier Plate - Removal

REMOVAL






NOTE: It may be necessary to have an assistant help with these steps.

1. Raise the window (1) into the position shown to gain access to the window tabs.
2. Remove the door trim bolster panel, Rear Door Trim Panel Bolster - Removal.
3. With a punch or equivalent, press the regulator tabs holding the window (1) in the regulator (2).
4. Disconnect the window (1) from the regulator (2).
5. Tape the window (1) into the full up position.





6. Loosen the lower screw (2).





7. Remove the speaker (2), Speaker - Removal.





8. Disconnect the exterior handle rod (1) from the latch (3).





9. Remove the latch screws (3).





10. Remove the trim screws (3) from the speaker opening.
11. Remove the trim cap (4) and the screw (2) at the inside handle.





12. Disconnect the main harness connector (1).
13. Remove the screws (3) from the door frame.





14. Remove the three upper fasteners (1).





15. Lift the module (1) up off of the four trim hooks (2) and lower regulator screw (4).
16. Pull the front of the trim module (1) out from the door and forward to remove the latch.





17. Separate the harness (2) from the door.