Mode Door Actuator - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury. Air Bag(s) Arming and Disarming






NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable. Service and Repair
2. On LHD models, remove the two push-pins and silencer panel from the passenger side of the instrument panel.
3. On LHD models, remove the glove box bin Instrument Panel Glove Box - Removal.
4. Remove the floor distribution duct from the right side of the HVAC air distribution housing Floor Distribution Duct - Removal.
5. Remove the three screws (1) that secure the mode door actuator (2) to the bracket (4) located on the right side of the air distribution housing.
6. Disconnect the wire harness connector (3) from the mode door actuator and remove the actuator.