Upper Instrument Panel Cover

INSTALLATION





1. Carefully place the upper instrument panel cover into position to the IP structure. Ensure the passenger airbag mounting studs are aligned.
2. Install the screws securing the upper IP cover (2) to the instrument panel (IP).
3. Install the passenger airbag mounting fasteners. Passenger Air Bag - Installation.
4. Connect the passenger airbag electrical connectors.





5. Install the glove box (2) to the hinges (1) using a twisting motion.





6. Raise the glove box (2) while squeezing the stop tabs (1) inward.
7. Install the driver and passenger side end caps.





8. Place the radio into position and connect the electrical connectors.
9. Install the radio mounting fasteners.
10. Place the center bezel (2) into position to the IP (1).
11. Connect the electrical connectors and the mechanical connections to the HVAC.
12. Fully seat the center bezel to the instrument panel (1).





13. Install the defroster grille (1) to the vehicle and seat fully.
14. Install the driver and passenger A-pillars from the vehicle.
15. Connect the battery negative cable.