Front

DISASSEMBLY

NOTE: Seat mechanical part description and specifications are found in seat description Front Seat - Description .





1. Before proceeding with the following repair procedure, review all warnings and cautions Service Precautions.
2. Remove the seat back Seat Back - Removal.
3. Remove the headrest by pressing in on the release tabs and pulling the headrest straight up.





4. Remove the lumbar handle, if equipped.
5. Remove the back panel (1).





6. Separate the J-straps (1) and the push-pin fasteners (2).





7. Release the push-pin fasteners (1) and release the cover from the hooks (2).





8. Separate the seat cover (3) from the foam cushion (1) and cut off all hog rings (2) attaching cover to the foam.





9. Using a small flat bladed tool (4) or equivalent, release the headrest sleeve retaining tabs through the openings (2) in the sleeve support piece.
10. Using a soft hammer (3) or equivalent, remove the headrest sleeves (1).
11. Remove the seat back cover and cushion.





12. Remove the lumbar adjuster screws (1).





13. Disconnect the lumbar cable (2) and separate the cable housing (1).





14. Release the lumbar mat side wires (1) by pulling out on the wire supports and then pulling them in.





15. Squeeze the lower support wires (1) in and release the lower wires.





16. Pull the upper support wires (1) down and release the lumbar mat from the seat back frame.