Leak Testing

LEAK TESTING

WARNING: If vehicle has been run recently, wait 15 minutes before removing pressure cap. Place a shop towel over the cap, and without pushing down, rotate it counterclockwise to the first stop. Allow fluids to escape through the overflow tube. When the system stops pushing coolant and steam into the coolant recovery container and pressure drops, push down on the cap and remove it completely. Squeezing the radiator inlet hose with a shop towel (to check pressure) before and after turning to the first stop is recommended.

With engine not running, wipe the coolant filler neck sealing seat clean. The radiator should be full.

Attach Tool 7700 or equivalent cooling system pressure tester to the coolant filler neck. Apply 104 kPa (15 psi) pressure. If the pressure drops more than 13 kPa (2 psi) in 2 minutes inspect all points for external leaks.

All hoses, radiator and heater, should be moved while at 104 kPa (15 psi) since some leaks occur while driving due to engine movement, etc.

If there are no external leaks after the gauge dial shows a drop in pressure, detach the tester. Start engine and run the engine to normal operating temperature in order to open the thermostat and allow the coolant to expand. Reattach the tester. If the needle on the dial fluctuates, it indicates a combustion leak and is usually a head gasket leak.

WARNING: With tool in place pressure builds up fast. Any excessive amount of pressure built up by continuous engine operation must be released to a safe pressure point. Never permit pressure to exceed 138 kpa (20 psi).

If the needle on the dial does not fluctuate, race the engine a few times. If an abnormal amount of coolant or steam is emitted from the tailpipe, it may indicate a damaged head gasket, cracked engine block or cylinder head.

There may be internal leaks which can be determined by removing the oil dipstick. If water globules appear intermixed with the oil, it will indicate an internal leak in the engine. If there is an internal leak, the engine must be disassembled for repair.