Compass And Mini-Trip Computer Module - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

1. Disconnect and isolate the battery negative cable.
2. Using a trim stick C-4755 or equivalent, remove the upper instrument panel cover located over the center bezel and radio.
3. Remove the screws securing the Remote Compass Module (RCM) to the upper instrument panel cover.
4. Disconnect the RCM electrical connector and remove the RCM from the vehicle.