Dome Lamp - Removal

LAMP





1. Disconnect and isolate the battery negative cable.
2. Insert the tip of a small flat bladed screwdriver into the notch (3) between the lens (1) and the housing (2) on the right side of the dome lamp unit.
3. Gently pry the end of the lens downward until it unsnaps from the housing.
4. Swing the lens downward until it is perpendicular to the housing.
5. Pull the housing downward far enough to disengage it from the rear speaker enclosure.
6. Pull the lamp away from the mounting hole in the speaker enclosure far enough to access and disconnect the wire harness connector from the connector receptacle on the back of the lamp housing.
7. Remove the lamp from the vehicle.