Service Procedure
NOTE:wiTECH must be used to perform this recall. This procedure must be performed with software release level 12.01 or higher. If the reprogramming flash for the PCM is aborted or interrupted, repeat the procedure.
A. Reprogram the PCM:
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.5 volts. Do not allow the charger to time out during the flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor to lower the voltage.
2. Connect the wiTECH VCI pod to the vehicle data link connector located under the steering column.
3. Place the ignition in the "RUN" position.
4. Open the wiTECH Diagnostic application.
5. Starting at the "Select Tool" screen, select the row/tool for the wiPOD device you are using.
6. Enter your "User id" and "Password", then select "OK."
7. Select the "Next" tab at the bottom of the screen.
8. From the "Vehicle View" screen, click on the PCM icon.
9. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current ECU Flash Number" is the same as the "New Part Number" continue to Step 18. If the part numbers are not the same, continue to Step 10.
10. With the cursor over the desired flash file, click the small green arrow button on the right side of the screen.
11. From the "ECU Flash" screen follow the wiTECH screen instructions to complete the flash.
B. Install the Authorized Modifications Label:
1. Type or print (with a ballpoint pen) the recall number, repair modification, dealer code and date on the Authorized Modifications Label (Figure 1).
2. Attach the label near the VECI label and then close the hood.
3. Complete Proof of Correction Form for California Residents.
NOTE:
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California for proof that this recall has been performed when they renew the vehicle registration.