Alarm Module: Testing and Inspection

INSPECTION

While operating the components, check whether the operations are normal with timing chart.

ETACS FUNCTION




1. Rear intermittent wiper.
Time specification
T: 5 ± 1 sec.
T1: 0.5 ± 0.25 sec.




2. Rear washer related wiper.
Time specification
T: 0.5 ± 0.25




3. Rear window defogger and front windshield defogger.
Time specification
T1: 15 ± 3 min.




4. Seat belt warning
Time specification
T1: 6 ± 1.5 sec.
T2: 0.5 ± 0.1 sec.




5. Ignition key hole illumination
Time specification
T: 30 ± 10




6. Delayed out room lamp
Time specification
T1: 4.5 ± 1.0 sec.
T2: 10 ± 2.0 sec.
T3: 20 ± 2 min.

1. Upon the front door or sliding door open with keyless switch OFF, the room lamp and courtesy lamp turns on for T3.
2. Upon the door switch OFF with ACC is OFF, the room lamp declines 100% to 0% for T1.
3. Upon the door switch OFF with ACC is ON, the room lamp turns on for T1.
4. The room lamp turns on for T1 when the door unlock signal is ON by RKE.




7. Ignition key reminder




8. Battery saver.




9. Power window timer
Time specification
T1: 30 ± 6 sec.




10. Sliding door lock
Time specification
T1: 0.5 ± 0.1 sec.







11. 2-Turn unlock
Time specification
T1: 3 ± 0.5 sec.
T2: 0.5 sec.




12. Door ajar




13. Parking on drive
Time specification
T1: 0.5 ± 0.1 sec.




14. Central door lock/unlock.




15. Light warning
16. Remote key less Entry system.




1. Door lock




2. Door unlock
Time specification
T1: 1.0 ± 2.0 sec.




3. Panic
Time specification
T1: 27 ± 2 sec.
T2: 0.5 ± 0.1 sec.

17. Code saving method
1. Connect the coding connector to the Diagnosis connector in order to jump between terminal 12 and terminal 16 if you have a coding connector, use a jumper wire between the above-mentioned terminals.
2. Turn the ignition switch to "ON" position.
3. Press LOCK button of transmitter two times. If success, the buzzer will operate for approximately one second.
4. Turn the ignition switch to "OFF" position and remove ignition key from key set.
5. Disconnect the codling connector from the diagnosis connect.




6. Check for LOCK and UNLOCK operation.