Driveshaft
Constant velocity shaftDisassembly
1. Disassemble in order shown on figure.
1. Disassemble the center bearing bracket from the inner shaft with SST (0951743001)
2. Press out the center bearing with SST (0921621 100, 09495-331 00)
Caution: Press SST (0949-33100) correctly to prevent deformation of the seal plate.
Assembly
Length of content velocity shaft
1. Apply multi-purpose grease to the center bearing and center bearing bracket inside.
2. Press the center bearing into the center bearing bracket with SST.(Pressure should be less than 1,500 kg)
3. Apply multi-purpose grease to the back face of every new dust seal.
Using the special tool, tap the outer dust seal and inner dust seal in that order until they are flush with the edge of the center bearing bracket.
4. Install the center bearing bracket to the inner shaft.