Programming and Relearning
SHINCHANG IMMOBILIZER (FOR CANADA)PASSWORD SETTING
Password can be used to register the master keys when you lost the ID key by using a tester (such as Hi-scan).
1. Initial password
The initial password for 1CM has been set by the manufacturer as 2345.
Key can be registered and corrected by using the initial password until a new password is registered
2. Password registration and change
Using a tester (Hi-scan), the initial password (preset as 2345 all) can be replaced by a new password nominated by the owner.
4 numbers among 0 - 9 can be registered as password. Once the password has been changed from 2345, the ICM is ready to record the ID code.
KEYS REGISTRATION AND CORRECTION
1. Initial registration method
2. Registration correction for master keys
In cases when the master key is lost or where a new set of master keys need to be produced, it can be achieved using two methods.
1. Using ID key
2. Using password
When the customers lost the ID key, new master keys can be registered by using Hi-scan only. ID key can not be corrected and reproduced.
NOTE: Once the password is mis-registered, it is impossible to register new password during 10 seconds regardless of ignition ON/OFF
When the new master keys have been registered, the codes for existing master keys are all cleared.
IMMOBILIZER LAMP
Immobilizer lamp is indicator the state of immobilizer system.
Cases of success (OK means):
Lamp should be blinked 6 times, when IG on, and then engine start is possible.
Cases of non-success (NG means):
If the transponder identification is failed or communication error is occurred, the lamp is continuously turned on and then the mode is entered into the limp home mode.
During limp home password entering sequence, the lamp reflects the IGN1 signal state : if IG is ON, then lamp is ON, if IG is OFF, the lamp is OFF
Only if the EMS is in status "learnt" and the user password status is "learnt" and the user password is the correct one, the EMS is unlocked for approximately 10 seconds. The engine can be started during this time. After elapsing of timer no engine start is possible. After new input of user password the time starts again.
After ignition off the EMS is locked. For next start the input of user password is requested again.
LIMP HOME (OVERRIDE) PROCEDURE BY IGNITION KEY
This procedure allows the unlocking of the EMS by entering the user password via the IG SW, in case the transponder code cannot be read or is unknown after ignition-ON, a valid transponder code must have been received, otherwise the EMS will remain "Locked" and the lamp will start blinking. This can happen through a malfunction of the transponder, the reading device or an unknown transponder code.
The number of IG ON/OFF must coincide with the password.