Alarm Module: Testing and Inspection
INSPECTIONWhile operating the components, check whether the operations are normal with timing chart.
ETACS FUNCTION
1. Rear window defroster and front windshield defroster.
Time specification T1: 15 ± 3 min.
2. Seat belt warning
Time specification: T1: 6 ± 1.5 sec.
3. Ignition key hole illumination
Time specification T: 30 ± 10 sec.
4. Decayed out room lamp
Time specification
T1: 4.5 ± 1.0 sec.
T2: 10 ± 2.0 sec.
1. Upon the front door or sliding door open with keyless switch OFF, the room lamp and courtesy lamp turns on for 20 minutes.
2. Upon the door switch OFF with ACC is OFF, the room lamp declines 100% to 0% for T1.
3. Upon the door switch OFF with ACC is ON, the room lamp turns on for T1.
4. The room lamp turns on for T2 when the door unlock signal is ON by RKE.
5. Ignition key reminder
6. Battery saver.
7. Time lag power window timer
Time specification T1: 30 ± 6 sec.
8. Sliding door lock
Time specification T1 : 0.5 ± 0.1 sec.
9. Door ajar warning
10. Parking on drive warning
Time specification T1 : 0.5 ± 0.1 sec.
11. Light warning
12. Two-Turn unlock
Time specification T1 : 3 ± 0.5 sec.
13.Central door lock/unlock.
14. Remote keyless Entry (R.K.E) system.
1. Door lock
2. Door unlock
Time specification T1 : 30 sec.
It the door will not be opened within 30 seconds, the door will be locked automatically.
3. Panic
Time specification T1 : 27 ± 2 sec.
15. Code saving method
1. Connect the coding connector to the Diagnosis connector in order to jump between terminal 12 and terminal 16 if you have a coding connector, use a jumper wire between the above-mentioned terminals.
2. Turn the ignition switch to "ON" position.
3. Press LOCK button of transmitter two times. If success, the buzzer will operate for approximately one second.
4. Turn the ignition switch to "OFF" position and remove ignition key from key set.
5. Disconnect the codling connector from the diagnosis connect.
6. Check for LOCK and UNLOCK operation.