On Vehicle Services
Wheel bearing play1. Raise vehicle and support it with safety stand.
2. Loosen and remove four wheel nuts.
3. Remove wheel and tire.
4. Loosen a lock nut and two disk plate screws.
5. Remove brake caliper assembly and disk plate.
6. Install a dial indicator on wheel hub and push and pull hub to measure bearing play.
Replace the knuckle assembly if necessary.
Maximum wheel bearing play: 0.002 inch (0.05 mm)
7. Install brake caliper assembly and disk plate.
8. Tighten a lock nut and two disk plate screws.
Tightening torque: Lock nut: 177 - 199 ft. lbs. (240 - 270 Nm, 24.5 - 27.5 kg.m)
Rotor screw: 7 - 11 ft. lbs. (9.8 - 15 Nm, 1.0 - 1.5 kg.m)
9. Install wheel and tire.
10. Tighten four nuts.
Tightening torque: 65 - 79 ft. lbs. (88 - 108 Nm, 9.0 - 11.0 kg.m)
11. Lower vehicle.