Trip Computer: Adjustments
ADJUSTMENTCORRECTION MODE
1. The correction process is necessary for displaying correct direction of by removing the effect of magnetized car body components.
2. Push Mode button for 2 sec - 4.5 sec. And then "turn" is displayed and "DIR" is blinking with 0.5 sec intervals.
3. Automatic correction is done when the vehicle turns 720 degrees in normal driving condition (the correction is invisible to the driver).
NOTE:
- The correction data is updated if the automatic correction data is better than the present correction data.
- Turning direction is not important.
- If the correction process is not finished after the vehicle turns 720 degrees, turn the vehicle some more degree.
4. After finishing the correction process, the compass displays the present direction.
5. If the correction process is not finished until 5 minutesthis mode is cancelled and the compass returns to normal mode with restoring the previous correction data.
DECLINATION CORRECTION (VARIANT REGION CHANGE MODE)
1. Change the "Declination Setting Value" according to the regional declination to synchronize the true north and vehicle's north.
2. Push the mode button longer than 4.5 Sec to enter the declination correction mode. ('DIR' is on)
3. Screen after 4.5 sec.
4. Push the reset button longer than 0.1 Sec to change the declination setting Value (Steps by 5" to East. After East 30, wraps to West 30)
5. Push the mode button more than 1 Sec, new data is stored on EEPROM and VFD displays normal direction.
6. Without any effective input for 30 seconds, the trip computer displays the previous declination angle with blinking for 2 sec and displays normal direction.
NOTE:
1. Do not install a ski rack, antenna, etc. that are attached to the vehicle using a magnet as anything attached to the roof of the vehicle with a magnet will effect compass operation.
2. If the compass deviates from the correct indication soon after repeated adjustment, have the compass checked at an authorized dealer.
3. The compass may not indicate the correct compass point in tunnels or while driving up or down a steep hill. (The compass returns to the correct compass point when the vehicle moves to an area where the geomagnetism is stabilized.)
- Declination correction and correction setting value is not deleted during the B (+) OFF: