Power Sliding Door Switch: Testing and Inspection

POWER SLIDING DOOR SWITCH

INSPECTION

OVERHEAD CONSOLE DOOR SWITCH INSPECTION
1. Check the overhead console door switch input/output value by using the diagnostic tool. If the operation of overhead console door switch is abnormal, check the IPM and replace.




2. When checking the overhead console switch operation, select a vehicle type and "IPM" menu.




3. Select a in panel module (IPM) and "CURRENT DATA".




4. Check the PSD PTG power control switch and PSD left/right switch.
5. Confirm that output is changed by the controlling ON/OFF of each switch on the overhead console.

DOOR HANDLE SWITCH INSPECTION
1. Check the power sliding door control module input/output value by using the diagnostic tool. If the operation of door control module is abnormal, replace power sliding door control module.




2. When checking handle switch operation, select a vehicle type and "POWER SLIDING/TAILGATE" menu.




3. Select the "POWER SLIDING DOOR" menu to check.




4. Select the sensor output. And then check the handle switch output value changed by the controlling PSD or PTG.
5. Check that the handle switch output changed from OFF to ON during PSD or PTG operation.

TRIM SWITCH INSPECTION
1. Check the trim switch input/output value by using the diagnostic tool. If the operation of rear area module (RAM) is abnormal, replace RAM.




2. When checking the trim switch operation, select a vehicle type and "IPM" menu.




3. Select a rear area module (RAM) and sensor output.




4. Check the value of RSD/LSD, left/right door switch.
5. Confirm that the door switch output is changed by the controlling ON/OFF switch on center pillar trim.

DETENT SWITCH INSPECTION




1. Detent switch detect the latch position within latch assembly.
2. Check the power sliding door control module in- put/output value by using the diagnostic tool.




3. When checking the detent switch, select a vehicle type and "POWER SLIDING/TAILGATE" menu.




4. Select the "POWER SLIDING DOOR"




5. Select the detent sensor output. And then check the detent switch output with operating power sliding door.

- Voltage and numerical value may be different from the real value.

6. If there is no change in output, change the latch assembly.

LATCH SWITCH INSPECTION
1. Check the power sliding door control module input/output value by using the diagnostic tool.




2. When checking the latch, select a vehicle type and "POWER SLIDING/TAILGATE menu.




3. Select the "POWER SLIDING DOOR"




4. Select the sensor output. And then check the unlatch feedback (Unlocked state) voltage while operating power sliding door in power mode.

- Voltage and numerical value may be different from the real value.

5. If there is no change in voltage, change the latch.

ANTI PINCH STRIP
1. Check the power sliding door control module input/output value by using the diagnostic tool. If the operation of door control module is abnormal, replace anti pinch strip control module.




2. When checking the anti pinch strip operation, select a vehicle type and "POWER SLIDING/TAILGATE" menu.




3. Select power sliding door.




4. Select the sensor output. And then check the anti pinch strip sensor output while operating power sliding door in power mode.
- Voltage and numerical value may be different from the real value.

5. Change the anti pinch strip sensor, if there is no change from OFF to ON during operation.