Body Control Module: Service and Repair

REPLACEMENT

IPM (IN-PANEL MODULE)
1. Disconnect the negative (-) battery terminal.




2. Remove the crash pad lower panel (A).




3. Remove the keyless antenna cable and IPM (Instrument Panel Module) (A) after loosening 3 nuts and disconnecting 5 connectors.
4. Installation is the reverse of removal.

FAM (FRONT AREA MODULE)
1. Disconnect the negative (-) battery terminal.
2. Remove the FAM cover from the engine room.




3. Remove the 2 FAM connectors (A) and battery terminal nut (B).




4. Remove the IPM (B) from the splash shield (C) after loosening the 3 IPM mounting bolts (A) and the IPM mounting clip.
5. Disconnect the connector from the splash shield.
6. Installation is the reverse of removal.

RAM (REAR AREA MODULE)
1. Disconnect the negative (-) battery terminal.
2. Remove the left luggage side trim.




3. Remove the RAM (A) after loosening the 7 connectors and the 3 RAM mounting bolts (A).
4. Installation is the reverse of removal.