Rear Side

REAR SIDE IMPACT SENSOR

REMOVAL
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the rear pillar trim.
3. Disconnect the Side Impact Sensor connector.




4. Remove the SIS mounting bolt then remove the Side Impact Sensor.

INSTALLATION
1. Be sure that the battery negative cable is disconnected.




2. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

Tightening torque : 1.0 - 1.4 kgf.m (9.5 - 13.6 Nm, 7.0 - 10.0 lb.ft)

3. Install the rear pillar trim.
4. Reconnect the battery negative cable.
5. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.