Overhaul

Sun Roof:

DISASSEMBLY

1. Remove motor.






CAUTION: When removing the motor, the guide assembly should always be in the fully closed position.




2. Remove drip rail.




3. Remove stopper.




4. Remove drip shoe and guide.










5. Remove slider.







6. Remove culisse and slider.




7. Remove sunshade.




8. Remove deflector.

REASSEMBLY

1. Install in reverse order of removal.




2. Align the position of slider when installing the motor. Be sure to align the center 'A' and 'B'.

CAUTION: Be sure to initiate the motor when removing and installing it.

3. Method of motor initialization.
1. Confirm the installation of glass.
The state of finishing gap control.







2. Press the "UP" switch. (The state of pressing switch).
After pressing "UP" switch for 3 - 5 seconds, the slider must be moved 5 mm forward.
3. Switch OFF after the slider has been moved 5 mm and switch "UP" again.(Switch is being pressed) If all conditions are normal, Sunroof will open and close once.
4. It makes initializing done to convert switch "UP" into "OFF" when the sunroof is closed.

4. The time to save initialization.
1. When operate the sunroof is operated for the first time.
2. When initial data is deleted or damaged by discharge or discontinuance of supply power.
3. Driver's need.
4. When the sunroof is operated manually.

5. In case that "TILT" doesn't operate when pressing TILT switch after the sunroof is closed on vehicle, refer to the following procedures.




1. Remove motor.




2. Adjust the motor to the stopping point, pressing the close switch.




3. Install motor after adjusting the position of slide as shown in the figure.
4. Initialize motor according to the way of initialization.