Displaying & Reading Trouble Codes
SELF-DIAGNOSIS FUNCTIONDESCRIPTION
^ If an error occurs in an electrical system, turn key SW ON. To identify the troubled part, input the self-diagnosis execution signal to output failure data memory to display the trouble part.
SELF-DIAGNOSIS
PROCEDURE
1. Warm up the engine.
2. Turn key SW ON, OFF over twice finally to OFF position (Wait five seconds).
3. Switch select lever to P range, key SW ON.
4. Turn key SW OFF.
5. Move select lever to D Range.
6. Turn Idle SW ON (Accelerator full close).
7. Turn brake SW ON.
8. Turn key SW ON.
9. Wait three seconds.
10. Turn sports mode SW ON (Move select lever to sports mode).
11. Turn brake SW OFF.
12. Turn sports mode SW OFF (Switch select lever to D range).
13. Turn brake SW ON.
14. Turn brake SW OFF.
15. Full release and full depress accelerator.
16. Finish diagnosis.
^ When an error code has occurred, check inhibitor, Sports mode, Brake, Idle, and Pull SW system.
HOW TO ERASE THE SELF DIAGNOSIS
^ To easily identify the cause of low-reproducing trouble, TCM remembers trouble data frequently for user. This memory is not removed even with several times of key SW ON and OFF but it is to be removed by self-diagnosis memory removal or key SW OFF after self-diagnosis.